Cart:

0 item(s) - £0.00
You have no items in your shopping cart.

0

Urinal Water Saver - Mains or Battery

More Views

    Urinal Water Saver - Mains or Battery

    Excl. Tax: £139.95 Incl. Tax: £167.94

    Quick Overview

     


    Reduced metered water bills:  can save up to 90% on your water bills. Full payback is typically seen within 12 months of purchase..
    Adjustable economy settings: Cycle time, from triggering to the end of the flush, may be set to 20, 30, 40 or 60 minutes. A maintenance flush occurs every 8, 12, or 24 hours, timed from the last flush.
    Fully automated: Using a  PIR sensor, the unit monitors the room and operates only when required. A hidden manual flush button can be used to start an extra flush and to check the battery state.
    Complies with legislation: Installing this unit complies with ‘The Water Supply (Water Fittings) Regulations 1999’. The valve used is WRAS approved. and  is also listed on the Governments water technology list (WTL).
    Proven reliability: Since 1991, thousands supplied to schools, restaurants, pubs, offices, factories, power stations etc. In fact, we know of original units installed in 1992 still on the go today!  battery packs are guaranteed to last a minimum of 3 years.
    Technical support: Free technical support is available by phone or email.

    Only 100 left

    * Required Fields

    Excl. Tax: £139.95 Incl. Tax: £167.94

    Details

    Supply Voltage
        

    6V DC (230V AC version optional)

    Battery life
        

    3-4 years with low cost alkaline battery pack supplied

    Low battery action
        

    Buzzer tweets near end of life then disables valve opening when critical

    Motion sensing
        

    PIR* with domed fresnel lens

    Detection area
        

    100 x 60 degrees beam width

    Detection range
        

    5m ahead, 2m at edge of beam. Optional reduced sensitivity setting

    Control valve
        

    Magnetically latching solenoid, 2mm orifice, 15mm compression fittings

    Max. water pressure
        

    12 bar

    Min. water pressure
        

    1m head; optional 4mm orifice valve available for very low pressures

    Fill time
        

    0-31 minutes, 1 second resolution

    Flush cycle time
        

    20, 30, 40 or 60 minutes set via switches

    Maintenance flush
        

    None, 8, 12 or 24 hour intervals

    Manual flush
        

    Hidden button on front of unit gives instant fill, enabled or disabled via internal switch

    Battery check
        

    Hold down manual flush button to show battery state

    Visual indication
        

    A red light in the dome flashes once on manual flush and at start of each cycle

    *PIR – Passive InfraRed detection, an electronic device which detects movement of body heat.

    Additional Information

    Noise OutputN/A
    Operating VoltageN/A
    Warm Air Speed OutputN/A
    Air Output TemperatureN/A
    Motor TypeN/A
    Motor Thermal ProtectionN/A
    Heater ElementN/A
    Heater Thermal ProtectionN/A
    Drying TimeN/A
    Circuit OperationN/A
    Timing ProtectionN/A
    Splash ResistanceN/A
    IsolationN/A
    Nett WeightN/A
    Unit SizeN/A
    WarrantyN/A

    Product Tags

    Use spaces to separate tags. Use single quotes (') for phrases.

    DO YOU WANT 10% OFF YOUR FIRST ORDER?
    Subscribe our newsletter and get voucher code - check junk folder
    Hand Dryer Calculations *Hand dryness is subjective and differs from individual to individual and your washroom conditions. Bremmer hand drying calculations are based on intensive real life testing.